If you are going to be doing an Advanced Geosciences resistivity survey on a large area of land - perhaps before a construction project begins - there are a few things that you should know. First, it is important to mark the land off clearly before you begin. This helps you see the boundaries so that you are not working in an area where you are not supposed to be and it also ensures that you really survey the entire space and do not miss anything.
Another thing to keep in mind is that you should use a transmitter that gives you a constant signal. This is known as an "alway on" system. Since the project is going to take a significant amount of time, you need to do everything in as efficient a way as possible. Any time wasted means that you might not get done on time, setting the project back. Even little things like turning the system on and off every time that you move to a new area in the grid can slow you down. With this style of transmitter, you do not have to worry about doing things like that, so you can concentrate on covering the area as quickly as possible.
Similarly, you probably want to use a transmitter with a wireless system. You can usually get the transmitters with either a wireless setup or a wired one. The wired setup is easier to use, so it is preferred for small jobs, but it is actually a lot harder to use on a large job since you have to keep moving it around. This adds a lot of labor to the project. A wireless transmitter can be set up at one point at the beginning of the day and then easily used for the whole job.
Finally, just make sure that you keep good records, writing down every step of the process as you get things done. For smaller jobs, it may be easy enough to remember what you did, but this is not always true for larger jobs. If you forget that you surveyed an area and you start to do it again, you are going to waste a lot of time. As you have seen from the tips above, time is of the essence. Taking a few seconds to jot down some notes can really help you avoid these types of setbacks.
Another thing to keep in mind is that you should use a transmitter that gives you a constant signal. This is known as an "alway on" system. Since the project is going to take a significant amount of time, you need to do everything in as efficient a way as possible. Any time wasted means that you might not get done on time, setting the project back. Even little things like turning the system on and off every time that you move to a new area in the grid can slow you down. With this style of transmitter, you do not have to worry about doing things like that, so you can concentrate on covering the area as quickly as possible.
Similarly, you probably want to use a transmitter with a wireless system. You can usually get the transmitters with either a wireless setup or a wired one. The wired setup is easier to use, so it is preferred for small jobs, but it is actually a lot harder to use on a large job since you have to keep moving it around. This adds a lot of labor to the project. A wireless transmitter can be set up at one point at the beginning of the day and then easily used for the whole job.
Finally, just make sure that you keep good records, writing down every step of the process as you get things done. For smaller jobs, it may be easy enough to remember what you did, but this is not always true for larger jobs. If you forget that you surveyed an area and you start to do it again, you are going to waste a lot of time. As you have seen from the tips above, time is of the essence. Taking a few seconds to jot down some notes can really help you avoid these types of setbacks.
0 comments :
Post a Comment
Only Comments which have valuable feedback are approved to reduce the spam comments. So, take a note that we approve only right feedback related to the article you comment.